Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
- 11. Coupling and power shafts
   11.2. General information
   + 11.3. Check and replacement of a disk of coupling
   + 11.4. Vyzhimna bearing
   + 11.5. Main cylinder of coupling
   + 11.6. Working cylinder of coupling
   11.7. Air removal from hydraulic system of coupling
   11.8. Starting switch of coupling
   + 11.9. Hinge of equal angular speeds (CV JOINT)
   - 11.10. Replacement of protective covers and repair of hinges of equal angular speeds
      - 11.10.1. Models with the engine 5S-FE
         11.10.1.2. Check
         11.10.1.3. Assembly
      + 11.10.2. Models with the engine 3VZ-FE or 1MZ-FE
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment



11.10.1.3. Assembly

GENERAL INFORMATION

Power shafts on models with engines 5S-FE
 
1–antidust cap;
2–blooming ring;
3–bearing;
4–intermediate shaft;
5–collars of fastening of protective covers;
6–Trekhplechy hinge;
7–protective cover;
8–protective cover;
9–lock ring;
10-collars of fastening of protective covers;
11-power shaft;
12-draft of the stabilizer of cross-section stability;
13-lock-nut;
14-шплинт;
15-tip of steering draft;
16-left power shaft;
17-lock ring;
18-lock ring;
19-bolt of fastening of the intermediate bearing;
20-right power shaft;
21-protection of a forward wing

Measurement of length of a power shaft on models with engines 5S-FE


PERFORMANCE ORDER
1. Wrap up a shlitsevy part of a power shaft a sticky tape and establish on a power shaft protective covers of hinges of equal angular speeds.
2. Remove a sticky tape with шлицов a power shaft and establish on a power shaft the three-humeral hinge and fix it a lock ring.
3. Fill with greasing the case of the hinge of equal angular speeds and grease the three-humeral hinge.
4. Establish the three-humeral hinge with a power shaft in the hinge case.
5. Establish a new protective cover on a power shaft so that the flange of a protective cover was established in flutes of a power shaft.
6. Moving the three-humeral hinge in the hinge case, establish the demanded length of a power shaft (see fig. Measurement of length of a power shaft on models with engines 5S-FE).
7. Using a screw-driver, let the air out from under a protective cover.
8. Fix a cover a collar.