Toyota Camry

1992-1997 of release

Repair and car operation

Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
- 11. Coupling and power shafts
   11.2. General information
   - 11.3. Check and replacement of a disk of coupling
      11.3.2. Check
      11.3.3. Installation
   + 11.4. Vyzhimna bearing
   + 11.5. Main cylinder of coupling
   + 11.6. Working cylinder of coupling
   11.7. Air removal from hydraulic system of coupling
   11.8. Starting switch of coupling
   + 11.9. Hinge of equal angular speeds (CV JOINT)
   + 11.10. Replacement of protective covers and repair of hinges of equal angular speeds
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment

11.3.2. Check

GENERAL INFORMATION

Main defects of a press disk

PERFORMANCE ORDER

	1. Check overlays of a disk of coupling on wear, mechanical damages or pollution by oil.
2. In the presence of these defects it is necessary to replace a disk of coupling.
3. If frictional slips in a good condition also are not worn-out to grooves, springs of a damper are reliably fixed and zaklepochny connections are not loosened, it is possible to establish a disk of coupling in the car.
4. If the disk of coupling is polluted by oil, check a back sealing ring of a cranked shaft or primary shaft of a transmission. If necessary replace a sealing ring before installation of a new disk of coupling.
5. Check knot of a leading disk on wear of a press disk, mechanical damages, reliability of zaklepochny connection, damage of a diafragmenny spring of coupling. If the diafragmenny spring is worn-out or damaged or there is a suspicion that elasticity of a spring changed, it is necessary to replace knot of a leading disk (see fig. Main defects of a press disk).
	6. Check working surfaces of a press disk and a flywheel, interfaced to overlays of a disk of coupling. They should be pure, flat and not have scratches and development.