Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
- 11. Coupling and power shafts
   11.2. General information
   + 11.3. Check and replacement of a disk of coupling
   + 11.4. Vyzhimna bearing
   - 11.5. Main cylinder of coupling
      11.5.2. Repair
      11.5.3. Installation
   + 11.6. Working cylinder of coupling
   11.7. Air removal from hydraulic system of coupling
   11.8. Starting switch of coupling
   + 11.9. Hinge of equal angular speeds (CV JOINT)
   + 11.10. Replacement of protective covers and repair of hinges of equal angular speeds
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment



11.5.2. Repair

GENERAL INFORMATION

Details of the main cylinder of coupling
 
1–spring pin;
2–cover;
3–float;
4–tank;
5–sealing ring;
6–spring;
7–pusher;
8–lock ring;
9–bracket;
10-шплинт;
11-draft;
12-protective cover;
13-washer;
14-piston;
15-case of the main cylinder of coupling

PERFORMANCE ORDER
1. Uncover a tank and merge liquid from the main cylinder. Using a hammer and a drift, beat out a pin of fastening and remove a tank from the main cylinder of coupling (see fig. Details of the main cylinder of coupling).
2. Remove from the case a dustproof cover and take a lock ring.
3. Take a washer and a pusher from the cylinder case.
4. Knock with the coupling cylinder on wooden whetstone to take the piston from the case of the main cylinder.
5. Remove a spring from the piston.
6. Remove a sealing ring from the piston.
7. Wash out all details of the main cylinder of coupling in pure brake liquid and check their condition.
8. Establish a sealing ring in a piston flute, thus working edges of a sealing ring should be from outside, opposite to a pusher.
9. Establish on the piston a spring.
10. Grease an opening of the cylinder and working edges a sealant a foot of a ring with fresh brake liquid and, being careful, establish the piston in the cylinder.
11. Establish a pusher with a washer, compress a spring and establish those a new lock ring.
12. Establish on the main cylinder of coupling a dustproof cover and a tank.