|
|
Toyota Camry1992-1997 of releaseRepair and car operation |
|
|
Kamri's Toyota + General data + 1. Maintenance + 2. Engine + 3. Six-cylinder V6 engines + 4. Major maintenance of engines + 5. Cooling and heating + 6. Fuel system + 7. Ignition system + 8. Toxicity fall + 9. Transmission + 10. Automatic transmission + 11. Coupling and power shafts + 12. Brake system + 13. Suspension bracket - 14. Body 14.1.1. Security measures at carrying out welding works + 14.2. Care of a body + 14.3. Care of an upholstery and rugs - 14.4. Repair of insignificant damages of a body 14.4.2. Repair of dents in a body design 14.4.3. Repair of the rusted openings or holes in a body design 14.4.4. Shpatlevka and body painting 14.5. Repair of strong damages of a body + 14.6. Cowl 14.7. Trunk lid 14.8. Back door + 14.9. Replacement of racks of support 14.10. Door upholstery + 14.11. Doors + 14.12. Lock, cylinder of the lock and handle of opening of a door 14.13. Door glass 14.14. Window regulator 14.15. Front bumper 14.16. Rear bumper 14.17. External rear-view mirrors + 14.18. Seats 14.19. Decorative overlay of a combination of devices 14.20. Casings of a steering column 14.21. Central console 14.22. Ware box 14.23. Check of a condition of seat belts 14.24. Front grille 14.25. Engine mudguard + 15. Electric equipment |
14.4.2. Repair of dents in a body design
At deep cave-in of elements of a design of a body first of all try to curve a dent back before the maximum approach to a normal form of a body. Body metal in a place of blow is exposed to a pulling therefore the complete recovery of an initial form is impossible. Optimum it is considered dent alignment approximately on 3 mm below level of a surrounding surface. If there is an access to dent inside, follows accurately выстучать its soft hammer with a wooden or plastic head. During this operation it is necessary to press densely to outer side of tapped area the corresponding wooden whetstone. It is required for amortization of blows of a hammer and for prevention of a flexure of more extensive area. If the dent is in that area of a body where access from a reverse side is complicated or impossible, in the deepest points of a dent drill some small openings, in openings screw up self-cutting screws and extend a dent by means of flat-nose pliers for acting heads of screws. Remove paint from the damaged area and at distance of 20 mm round it. Most easily it can be executed, using a wire brush or an emery paper got on a circle, fixed in an electrodrill. After alignment of a dent put on it a layer of a shpaklevka, paint and a polyrole. |
|