Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
- 15. Electric equipment
   15.2. General information
   15.3. Electric chains
   + 15.4. Detection of not closed chain
   15.5. Safety locks
   15.6. Relay
   + 15.7. Multipurpose switches of a steering column
   - 15.8. Ignition lock
      15.8.2. Replacement
   15.9. Switch of a heater of back glass
   15.10. Check of a heater of back glass
   15.11. Radio receiver
   15.12. Loudspeakers
   15.13. Aerial
   15.14. Replacement of bulbs of headlights
   15.15. Adjustment of light of headlights
   15.16. Headlight
   + 15.17. Replacement of bulbs of an incandescence
   + 15.18. Screen wiper engine
   15.19. Combination of devices
   15.20. Sound signal
   15.21. System cruise control
   15.22. Window regulators with an electric drive
   15.23. System of the central blocking of locks
   15.24. Rear-view mirrors with the electric drive
   15.25. Safety airbag
   + 15.26. Electric equipment schemes
вакансии - Москва



15.8.2. Replacement

GENERAL INFORMATION

Details of the lock of ignition
 
1–contact group of the lock of ignition;
2–solenoid of blocking by a key;
3–cylinder of the lock of ignition;
4–element of illumination of the lock of ignition;
5–case of the lock of ignition;
6–bracket of fastening of the lock of ignition;
7–top part of a steering column

PERFORMANCE ORDER
1. Remove a branch pipe of system of heating and the ventilation, located under a steering column.
2. Unscrew the screws, fixing a back part of the lock of ignition and remove the ignition lock (see fig. Details of the lock of ignition).
3. Remove a decorative ring of a frame of the cylinder of the lock of ignition.
4. Establish the ignition key in the ignition lock in situation ASS and through an opening in the case of the lock of ignition press a clamp and for a key take the cylinder of the lock of ignition.
5. Installation is made in sequence, return to removal.