Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
- 1. Maintenance
   1.2. Periodicity of service
   - 1.3. Maintenance
      + 1.3.1. Each 400 km or weekly
      + 1.3.2. Each 5 000 km or 3 months
      + 1.3.3. Each 10 000 km or 6 months
      - 1.3.4. Each 25 000 km or 12 months
         - 1.3.4.1.1. Disk brakes
            1.3.4.1.2. Drum-type brakes
            1.3.4.1.3. Check of the vacuum amplifier of brakes
            1.3.4.1.4. Check of the hand brake
            1.3.4.1.5. Free wheeling and height of installation of a pedal of a brake
         1.3.4.2. Replacement of the air filter
         1.3.4.3. Check of fuel system
         1.3.4.4. Check of level of oil in the main transfer
         + 1.3.4.5. Suspension bracket and steering check
         1.3.4.6. Check of a protective cover of a power shaft
      + 1.3.5. Each 50 000 km or 24 months
      + 1.3.6. Each 100 000 km or 48 months
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment



1.3.4.1.1. Disk brakes

GENERAL INFORMATION

In disk brakes two brake shoes are applied: external and internal. Blocks are visible through viewing openings in supports

PERFORMANCE ORDER

1. Check thickness of brake shoes and, if necessary, replace them.

2. If it is visually difficult to define thickness of brake shoes, remove a support and take brake shoes for further survey. Measure thickness of brake shoes, thus, if thickness of a frictional layer less admissible, replace a brake shoe.
3. Measure thickness of brake disks by means of a micrometer. If thickness of a brake disk less admissible, replace a brake disk. Replacement of a brake disk is made also in the presence of cracks, zones of an overheat and other damages.
4. Before installation of wheels check a condition of brake hoses and freedom of moving of brake hoses. Thus there should be no a contact to any sharp sides.