Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
+ 1. Maintenance
- 2. Engine
   2.2. Operations on engine repair on the car
   2.3. Top dead point of the first cylinder
   + 2.4. Cover of a head of the block of cylinders
   + 2.5. Inlet collector
   + 2.6. Final collector
   + 2.7. Gear belt and pulleys
   2.8. Replacement of a forward sealing ring of a cranked shaft
   2.9. Replacement of a sealing ring of a camshaft
   - 2.10. Camshaft and pushers
      + 2.10.1.1. A camshaft operating final valves
      2.10.2. Check
      - 2.10.3. Installation
         2.10.3.2. A camshaft operating final valves
   + 2.11. Head of the block of cylinders
   + 2.12. Oil pallet
   + 2.13. Oil pump
   + 2.14. Drive flywheel / plate
   2.15. Replacement of a back sealing ring of a cranked shaft
   + 2.16. Suspension bracket of the power unit
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment
вакансии - Москва



2.10.3. Installation

2.10.3.1. A camshaft operating inlet valves

PERFORMANCE ORDER
1. Grease pushers with pure engine oil and establish them into place. Check that adjusting laying установ Lena in pushers.
2. Grease necks of bearings and camshaft cams with pure engine oil.


3. Establish a camshaft in a head of the block of cylinders so that the adjusting pin was turned on 80 ° to the left from the vertical line.
4. Apply a thin film hermetic on an interfaced surface of a forward cover of a camshaft according to drawing.
5. Establish covers of bearings of a camshaft according to labels, and shooters should be directed to a forward part of the engine.
6. Gradually and consistently in an order shown in drawing, tighten bolts of fastening of covers of bearings of a camshaft.
7. Establish a new oil sealing ring of a camshaft.