Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
- 3. Six-cylinder V6 engines
   3.2. General information
   3.3. The repair which is not demanding removal of the engine
   + 3.4. Top dead point (VMT) of the piston of the first cylinder
   - 3.5. Cover of a head of the block of cylinders
      3.5.1.2. Installation
      - 3.5.2. Engine 1MZ-FE
         3.5.2.2. Installation
   + 3.6. Inlet collector
   3.7. Final collector
   + 3.8. Gear belt and pulleys
   3.9. Replacement of a forward sealing ring of a cranked shaft
   3.10. Replacement of sealing rings of camshafts
   + 3.11. Camshafts and pushers
   + 3.12. Head of the block of cylinders
   + 3.13. Oil pallet
   + 3.14. Oil pump
   3.15. Drive flywheel / plate
   3.16. Replacement of a back sealing ring of a cranked shaft
   3.17. Suspension bracket of the power unit
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment



3.5.2. Engine 1MZ-FE

3.5.2.1. Removal

GENERAL INFORMATION

Preventions

At existence in a code radio receiver against theft, before an accumulator detachment, check that you have connection codes.

On models since 1993 the system of an airbag of safety is disconnected, if the accumulator is disconnected for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for restoration of operability of system.


PERFORMANCE ORDER

1. Remove a weight wire from the accumulator.

2. For removal of a cover from a back head of the block of cylinders, remove a casing of the air filter, a throttle and an air inlet.

3. For removal of a cover from a forward head of the block of cylinders disconnect the electric socket from the coil of ignition and remove the coil of ignition and unscrew spark plugs.
4. Unscrew two nuts and five bolts. 5. Disconnect brackets of fastening of a back plait of wires and move a plait of wires aside. 6. Unscrew bolts of fastening and remove a head of the block of cylinders.