Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
- 5. Cooling and heating
   5.2. General information
   5.3. Antifreeze
   5.4. Hoses of system of cooling
   + 5.5. Check and thermostat replacement
   - 5.6. Check and replacement of the fan of a radiator and relay
      5.6.2. Relay check
      5.6.3. Replacement
   + 5.7. The radiator fan (the V6 models from 1992 to 1994)
   + 5.8. Radiator
   5.9. Broad tank
   + 5.10. Water pump
   + 5.11. The sensor of temperature of cooling liquid
   5.12. Heater fan
   5.13. Resistor of the fan of a heater
   5.14. Heater radiator
   + 5.15. Control panel heater
   5.16. Air central air
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment



5.6.3. Replacement

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.

Preventions

At existence in a code radio receiver against theft, before an accumulator detachment, check that you have connection codes.

On models since 1993 the system of an airbag of safety is disconnected, if the accumulator is disconnected for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for restoration of operability of system.


2. Disconnect the electric socket from the engine of the fan of a radiator.
3. On models about cruise control remove a casing of the executive mechanism cruise control for more convenient removal of the fan of a radiator. 4. Unscrew bolts of fastening of a casing of the fan to a radiator and remove fan assembly from the car.
5. Holding fan blades from a provorachivaniye, unscrew a nut of fastening and remove the fan from the engine. 6. Unscrew bolts of fastening of the engine of the fan of a radiator to a fan casing.
7. Installation is made in sequence, return to removal.