Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
- 6. Fuel system
   6.2. General information
   6.3. Pressure removal in fuel system
   + 6.4. Check of the fuel pump
   6.5. Fuel pump
   + 6.6. Fuel level sensor
   6.7. Fuel tank
   6.8. Air filter
   + 6.9. Accelerator cable
   6.10. Electronic system of injection of EFL fuel
   + 6.11. Fuel system
   6.12. Check of system of injection of fuel
   - 6.13. Check and replacement of elements of system of injection of EFI fuel
      6.13.1.2. Replacement
      + 6.13.2. Sensor of provision of a butterfly valve (TPS)
      6.13.3. Regulator of pressure of fuel
      + 6.13.4. Nozzle of cold start of the engine (V6 engine 3VZ-FE)
      + 6.13.5. Timer of a nozzle of cold start of the engine of the V6 model 3VZ-FE
      + 6.13.6. Control air valve (IAC)
   6.14. Fuel highway and fuel nozzles
   + 6.15. Valve of a mode of idling of central air of air
   6.16. Air inlet chamber (only V6 engines)
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment



6.13.1.2. Replacement

GENERAL INFORMATION

Details of the case of a throttle

1–additional air hose;
2–a hose of supply of cooling liquid;
3–throttle cable;
4–accelerator cable;
5–EVAP hose;
6–sensor of temperature of EGR;
7–vacuum hose;
8–laying;
9–EVAP hose;

10-throttle case;
11-socket of the sensor of provision of a butterfly valve;
12-arm of the sensor of temperature of EGR;
13-socket of the sensor of temperature of EGR;
14-IAC valve socket;
15-air inlet hose;
16-a hose of supply of cooling liquid


PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.

Preventions

At existence in a code radio receiver against theft, before a detachment of the accumulator check that you have connection codes.

On models since 1993 the system of an airbag of safety is disconnected, if the accumulator is disconnected for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for restoration of operability of system.


2. Merge cooling liquid from a radiator.
3. Weaken collars and remove an air inlet hose. Disconnect an accelerator cable from a control lever a butterfly valve and a cover of a cable of an accelerator from the throttle case.
4. Mark and disconnect vacuum hoses and hoses of supply of cooling liquid from the throttle case.
5. Disconnect the electric socket from the sensor of provision of a butterfly valve.
6. Unscrew 4 bolts of fastening of the case of a throttle.
7. Remove the throttle case with laying from an inlet collector (see fig. Details of the case of a throttle).
8. Using a soft brush, clear the throttle case, then blow all channels the compressed air.
9. Installation of the case of a throttle is made in sequence, return to removal.