Toyota Camry
1992-1997 of release
Repair and car operation
Kamri's Toyota
+
General data
+
1. Maintenance
+
2. Engine
+
3. Six-cylinder V6 engines
+
4. Major maintenance of engines
+
5. Cooling and heating
-
6. Fuel system
6.2. General information
6.3. Pressure removal in fuel system
+
6.4. Check of the fuel pump
6.5. Fuel pump
+
6.6. Fuel level sensor
6.7. Fuel tank
6.8. Air filter
+
6.9. Accelerator cable
6.10. Electronic system of injection of EFL fuel
+
6.11. Fuel system
6.12. Check of system of injection of fuel
-
6.13. Check and replacement of elements of system of injection of EFI fuel
6.13.1.2. Replacement
-
6.13.2. Sensor of provision of a butterfly valve (TPS)
6.13.2.2. Replacement
6.13.3. Regulator of pressure of fuel
+
6.13.4. Nozzle of cold start of the engine (V6 engine 3VZ-FE)
+
6.13.5. Timer of a nozzle of cold start of the engine of the V6 model 3VZ-FE
+
6.13.6. Control air valve (IAC)
6.14. Fuel highway and fuel nozzles
+
6.15. Valve of a mode of idling of central air of air
6.16. Air inlet chamber (only V6 engines)
+
7. Ignition system
+
8. Toxicity fall
+
9. Transmission
+
10. Automatic transmission
+
11. Coupling and power shafts
+
12. Brake system
+
13. Suspension bracket
+
14. Body
+
15. Electric equipment
6.13.2. Sensor of provision of a butterfly valve (TPS)
6.13.2.1. Check
GENERAL INFORMATION
Resistance check between the corresponding contacts of the sensor of provision of a butterfly valve on four-cylinder engines
Resistance check between the corresponding contacts of the socket of the sensor of provision of a butterfly valve on six-cylinder engines
PERFORMANCE ORDER
1.
Disconnect the electric socket from the sensor of provision of a butterfly valve (TPS) and submit vacuum to a pozitsioner of a throttle.
2.
Establish щуп in the thickness of 0,7 mm between the screw of adjustment of turns of idling and an emphasis.
3.
Using an ohmmeter, measure resistance between the corresponding pairs of contacts of the electric socket (see fig.
Resistance check between the corresponding contacts of the sensor of provision of a butterfly valve on four-cylinder engines
and fig.
Resistance check between the corresponding contacts of the socket of the sensor of provision of a butterfly valve on six-cylinder engines
).
If the measured resistance differs from demanded values, establish щуп in the thickness of 0,7 mm between the screw of adjustment of turns of idling and an emphasis and connect an ohmmeter to contacts of IGL and Е2. Weaken screws of fastening of the sensor of provision of a butterfly valve and slowly rotate the sensor clockwise while the ohmmeter will not show infinity.
4.
Tighten screws of fastening of the sensor of provision of a butterfly valve, establish щуп and repeatedly measure resistance between the corresponding contacts.