Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
- 6. Fuel system
   6.2. General information
   6.3. Pressure removal in fuel system
   + 6.4. Check of the fuel pump
   6.5. Fuel pump
   + 6.6. Fuel level sensor
   6.7. Fuel tank
   6.8. Air filter
   + 6.9. Accelerator cable
   6.10. Electronic system of injection of EFL fuel
   + 6.11. Fuel system
   6.12. Check of system of injection of fuel
   - 6.13. Check and replacement of elements of system of injection of EFI fuel
      6.13.1.2. Replacement
      + 6.13.2. Sensor of provision of a butterfly valve (TPS)
      6.13.3. Regulator of pressure of fuel
      + 6.13.4. Nozzle of cold start of the engine (V6 engine 3VZ-FE)
      - 6.13.5. Timer of a nozzle of cold start of the engine of the V6 model 3VZ-FE
         6.13.5.2. Replacement
      + 6.13.6. Control air valve (IAC)
   6.14. Fuel highway and fuel nozzles
   + 6.15. Valve of a mode of idling of central air of air
   6.16. Air inlet chamber (only V6 engines)
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment



6.13.5. Timer of a nozzle of cold start of the engine of the V6 model 3VZ-FE

6.13.5.1. Check

GENERAL INFORMATION

The timer is located near the sensor of temperature of cooling liquid.

PERFORMANCE ORDER
1. Disconnect the electric socket from a timer of a nozzle of cold start of the engine and, using an ohmmeter, check resistance between the corresponding contacts of the relay.
At temperature of the engine be lower 15 ° About resistance of a winding of a timer owe 25–45 Ohm.
At engine temperature more than 30 ° About resistance of a winding of a timer should be in limits of 65-85 Ohm.
2. Check resistance between contact of FTA and weight. It should make 25–85 Ohm.