Toyota Camry

1992-1997 of release

Repair and car operation


Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
- 7. Ignition system
   7.2. Accumulator
   + 7.3. Ignition system
   + 7.4. Check of system of ignition
   + 7.5. Ignition coil
   + 7.6. Ignition distributor
   7.7. Check and adjustment of a corner of an advancing of ignition
   7.8. Block ignitions (switchboard)
   + 7.9. Sensor of impulses
   7.10. Charging system
   7.11. Generator
   7.12. Check and replacement of components of the generator
   7.13. System of start of the engine
   7.14. Starter
   7.15. Traction relay
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment



7.11. Generator
GENERAL INFORMATION
Preventions

At existence in a code radio receiver against theft, before an accumulator detachment, check that you have connection codes.

On models since 1993 the system of an airbag of safety is disconnected, if the accumulator is disconnected for long term. If a control lamp of a pillow безопаснос ти it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for restoration of operability of system.

Connection of contact of F of the generator with weight at check of operability of the generator

  

The scheme of connection of measuring devices for check of operability of the generator

 

Elements of fastening of the generator of the four-cylinder engine

 
1–sharnirny bolt;
2–adjusting bolt;
3–electric wire;
 4–electric socket;
5–generator;
6–driving belt

Elements of fastening of the generator on the six-cylinder engine

 
1–tightening bolt;
2–sharnirny bolt;
3–washer;
4–electric wire;
 5–electric socket;
6–adjusting bolt;
7–generator;
8–driving belt

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. Disconnect electric wires from the generator.

3. Weaken fastening adjusting and sharnirny bolts of the generator and remove a driving belt.

4. Unscrew two bolts of fastening of an arm of the generator and remove the generator together with an arm.
5. Installation is made in sequence, return to removal.
6. After installation of the generator adjust a tension of a driving belt.