Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
- 8. Toxicity fall
   8.2. General information
   8.3. System of electronic control (TCCS)
   8.4. Self-diagnostics system
   - 8.5. Sensors
      8.5.2. Oxygen sensor
      8.5.3. Sensor of provision of a butterfly valve
      8.5.4. Measuring instrument of a stream of air (only V6 engines 3VZ-FE)
      8.5.5. MAF sensor of measurement of weight of a stream of air (V6 engine 1MZ-FE)
      8.5.6. Sensor of absolute pressure (four-cylinder engines)
      8.5.7. Sensor of temperature of EGR
      8.5.8. Sensor of speed of the car
      8.5.9. The detonation sensor (only with V6 engines)
      8.5.10. Sensor of provision of a camshaft (V6 engine 1MZ-FE)
      8.5.11. Sensor of an angle of rotation of a cranked shaft (only V6 engines 1MZ-FE)
   + 8.6. Induction system of supply of air in the engine (ACIS)
   8.7. Catching system паров fuels (EVAP)
   + 8.8. System of repeated burning of exhaust gases (EGR)
   8.9. System of ventilation of a case (PCV)
   8.10. Catalyst
   8.11. Codes of malfunctions
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment



8.5.6. Sensor of absolute pressure (four-cylinder engines)

GENERAL INFORMATION

Dependence of change of resistance of the sensor of temperature of air arriving in the engine on temperature
 

The sensor of absolute pressure in an inlet collector induces a signal from 4 In in the absence of vacuum to 0,5 In in the presence of vacuum.

PERFORMANCE ORDER
1. Include ignition, but do not start the engine and check tension from MAR-datchika which on a red wire there should be about 5 Century. 2. Remove a vacuum hose with MAR-datchika and instead of it connect the manual vacuum pump.
3. Disconnect the electric socket from MAR-datchika. Using the voltmeter, check the tension induced MAR-datchikom on a black/yellow wire. In the absence of vacuum tension should be about 4 In, and at vacuum creation it should decrease till 0,5 Century.
4. The sensor of temperature of air arriving in the engine is located in the case of the air filter. Resistance of the sensor changes depending on quantity postupayushche го in the air engine.
5. For check of the sensor of temperature of air arriving in the engine remove from the sensor the electric socket, include ignition, but do not start the engine.
6. Measure on the electric socket tension which should make 5 Century.
7. Connect an ohmmeter to contacts of the sensor of temperature of air arriving in the engine and at various temperatures measure resistance of the sensor.