Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
- 1. Maintenance
   1.2. Periodicity of service
   + 1.3. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment



1. Maintenance

1.1. Technical characteristics

GENERAL INFORMATION

Arrangement of cylinders and the direction of rotation of the distributor of ignition on the engine 5S-FE

Arrangement of cylinders and the direction of rotation of the distributor of ignition on the engine 3VZ-FE

On the engine 1MZ-FE an arrangement of cylinders similar, but without the ignition distributor.

Card of viscosity of engine oil

Motor compartment of the four-cylinder engine
1–tank of the amplifier of a steering;
2–cover of a maslozalivny mouth;
3–spark plugs;
4–distributor cover;
5–tank of brake liquid;
6–air filter;
7–accumulator;
8–щуп for measurement of level of oil in an automatic transmission;
9–щуп for measurement of level of engine oil;
10-oil filter;
11-radiator stopper;
12-radiator hose;
13-tank of a washer of a windscreen;
14-broad tank

Motor compartment of the six-cylinder engine
1–tank of brake liquid;
2–air filter;
3–accumulator;
4–щуп for measurement of level of oil in automATI to a chesky transmission;
5–cover of a maslozalivny mouth;
6–oil filter;
7–щуп for measurement of level of engine oil;
8–radiator hose;
9–tank of a washer of a windscreen;
10-broad tank;
11-tank of the amplifier of a steering

Bottom view of a motor compartment
1–masloslivny stopper;
2–brake support;
3–external hinge of equal angular speeds;
4–steering transfer;
5–a stopper oil plum from an automatic transmission;
6–exhaust pipe;
7–internal hinge of equal angular speeds;
8–brake hose

Bottom view of a back part of the car
1–fuel hose;
2–rack of a back suspension bracket;
3–fuel tank;
4–exhaust pipe;
5–cable of the hand brake

Recommended lubricants and liquids

Type of engine oil
all-weather API SG or SG/CD oil
Fuel
unleaded gasoline with octane number not less than 87
Cooling liquid
50 % of antifreeze on a basis этиленгликоля and 50 % of water
Oil of an automatic transmission
DEXRON II
Oil of a mechanical transmission
API GL-3, GL-4 or GL-5 75W-90
Type of brake liquid
DOT 3
Liquid type for coupling
DOT 3
Liquid of system of the amplifier of a steering drive
DEXRON II

Refueling capacities

Engine oil (including the filter):
– engine 5S-FE
3,8 l
– engine 3VZ-FE
4,5 l
– engine 1MZ-FE
5,0 l
Cooling liquid:
– engine 5S-FE
6,7 l
– engine 3VZ-FE
8,9 l
– engine 1MZ-FE
9,2 l
Automatic transmission:
– engine 5S-FE
plums and filling
2,6 l
between MIN and MAX labels
1,7 l
– engine 3VZ-FE
plums and filling
3,3 l
between MIN and MAX labels
0,8 l
– engine 1MZ-FE
plums and filling
3,7 l
between MIN and MAX labels
0,9 l

Ignition system

Spark plugs and interelectrode gap:
– engine 5S-FE
type
NGK BKR6EP-11 or equivalent
interelectrode gap
1,1 mm
– engine 3VZ-FE
type
NGK BCPR6EP-11 or equivalent
interelectrode gap
1,1 mm
– engine 1MZ-FE
type
NGK BKR6EP-11 or equivalent
interelectrode gap
1,1 mm
Resistance of a high-voltage wire of a spark plug
less than 25 000 Ohm
Operating procedure of cylinders of the engine:
– engine 5S-FE
1–3–4–2
– engine 3VZ-FE
1–2–3–4–5–6
– engine 1MZ-FE
1–2–3–4–5–6

Gap of valves (on the cold engine)

– engine 5S-FE
inlet valve
0,17-0,28 mm
final valve
0,28-0,38 mm
– engine 3VZ-FE
inlet valve
0,13-0,23 mm
final valve
0,28-0,38 mm
– engine of 1 MZ-FE
inlet valve
0,15-0,25 mm
final valve
0,25-0,35 mm

Cooling system

Thermostat
Temperature of the beginning of opening
89 ° With
Temperature of complete opening
100 ° With

Brakes

Minimum thickness of an overlay of a brake shoe of disk brakes
1,6 mm
Minimum thickness of an overlay of a brake shoe of disk brakes
1,6 mm
Brake pedal
Free wheeling
0,8-6,5 mm
Installation height
146 mm
Люфт stoplight switch
0,8-2,4 mm
Minimum height of a pedal
70 mm
Adjustment of the parking brake
Lever type
5–8 clicks
Pedal type
3–6 clicks

Tightening moments

Drain stopper of an automatic transmission
50 Nanometers
Drain and jellied jams of oil of a mechanical transmission
50 Nanometers
Bolts of fastening of a wheel
105 Nanometers
Bolt of fastening of forward sitting
37 Nanometers
Forward suspension bracket to a body
180 Nanometers
Bolts of a back suspension bracket to a body
models to 1992
115 Nanometers
models with 1993
55 Nanometers
Spark plugs
18 Nanometers

Suspension bracket and steering

Free wheeling of a steering wheel
30 mm
Люфт spherical hinge
0 mm

Tension of a driving belt (with Burroughs or Nippondenso measuring instrument)

– engine 5S-FE
the generator (with the conditioner)
new belt
77-80 kgfs
reusable belt
55-65 kgfs
the generator (without the conditioner)
new belt
45-70 kgfs
reusable belt
35-55 kgfs
pump of the amplifier of a steering
new belt
55-65 kgfs
reusable belt
27-55 kgfs
– engine 3VZ-FE
generator
new belt
77-80 kgfs
reusable belt
45-60 kgfs
pump of the amplifier of a steering
new belt
70-85 kgfs
reusable belt
45-60 kgfs
– engine 1MZ-FE
generator
new belt
80-85 kgfs
reusable belt
45-60 kgfs
the pump of the strengthened steering
new belt
70-85 kgfs
reusable belt
45-60 kgfs