Toyota Camry

1992-1997 of release

Repair and car operation

Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
- 11. Coupling and power shafts
   11.2. General information
   + 11.3. Check and replacement of a disk of coupling
   + 11.4. Vyzhimna bearing
   + 11.5. Main cylinder of coupling
   + 11.6. Working cylinder of coupling
   11.7. Air removal from hydraulic system of coupling
   11.8. Starting switch of coupling
   + 11.9. Hinge of equal angular speeds (CV JOINT)
   + 11.10. Replacement of protective covers and repair of hinges of equal angular speeds
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment

11.7. Air removal from hydraulic system of coupling

GENERAL INFORMATION

The union of pumping is located sideways the working cylinder of coupling.

PERFORMANCE ORDER

1. Unscrew a cover of a nutritious tank and check, that level of brake liquid in a tank was up to standard of max label. At removal of air watch availability of liquid in a tank, without allowing an exposure of its bottom as thus air again will get to system.

2. Remove a dustproof cap from the union of pumping and put on it the pure transparent hose which other end is necessary for lowering in the capacity which has been partially filled with brake liquid.

3. Sharply press a coupling pedal several times from intervals of 2-3 seconds. Unscrew on a turn floor the pumping union at the pressed pedal. Continuing to press a pedal, force out the liquid which was in system together with air through a hose in capacity. After the pedal will reach extreme forward situation and liquid replacement through a hose will stop, screw the pumping union home.

4. Repeat these operations, the air outlet from a hose will not stop yet.

5. Holding a pedal in the pressed situation, screw up the union against the stop and remove a hose.

6. Wipe the union of pumping and establish a protective cap.