п»ї Repair and Toyota Camry car operation - 11.5. Main cylinder of coupling//Kamri's Toyota of 1992-1997 / frndl.ru

Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
- 11. Coupling and power shafts
   11.2. General information
   + 11.3. Check and replacement of a disk of coupling
   + 11.4. Vyzhimna bearing
   - 11.5. Main cylinder of coupling
      11.5.2. Repair
      11.5.3. Installation
   + 11.6. Working cylinder of coupling
   11.7. Air removal from hydraulic system of coupling
   11.8. Starting switch of coupling
   + 11.9. Hinge of equal angular speeds (CV JOINT)
   + 11.10. Replacement of protective covers and repair of hinges of equal angular speeds
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment
нейрорубин форте лактаб вакансии - Москва



11.5. Main cylinder of coupling

11.5.1. Removal

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
Preventions

At existence in a code radio receiver against theft, before a detachment of the accumulator check that you have connection codes.

On models since 1993 the system of an airbag of safety is disconnected, if the accumulator is disconnected for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for restoration of operability of system.


2. Under the dashboard disconnect a pusher from the top part of a pedal of coupling.
3. Unscrew the pipeline in a back part of the main cylinder of coupling.
4. In salon of the car unscrew nuts of fastening of the main cylinder of coupling to a partition of a motor compartment and, being careful, remove the main cylinder of coupling.