Kamri's Toyota
+ General data
- 1. Maintenance
1.2. Periodicity of service
- 1.3. Maintenance
+ 1.3.1. Each 400 km or weekly
- 1.3.2. Each 5 000 km or 3 months
1.3.2.2. Control of level of oil in an automatic transmission
1.3.2.3. Replacement of oil and oil filter
+ 1.3.3. Each 10 000 km or 6 months
+ 1.3.4. Each 25 000 km or 12 months
+ 1.3.5. Each 50 000 km or 24 months
+ 1.3.6. Each 100 000 km or 48 months
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment
|
Prevention
If at the fulfilled engine oil there is a metal shaving, it usually indicates wear of radical or shatunny bearings of a cranked shaft.
Tools necessary for replacement of oil and the oil filter
|
|
1–the flat wide container for oil plum;
2–rubber gloves for an exception of hit of hot oil on hands;
3–the extended handle of a key;
4–a key for unscrewing of a masloslivny stopper;
5–a special key for unscrewing of the oil filter;
6–a special key for unscrewing of the oil filter, established on a back part of the filter |
Greasing of a sealing ring of the new oil filter by engine oil
Periodic replacements of oil and the filter – the most important preventive procedures of maintenance. When engine oil grows old, it becomes liquid and is polluted ny that conducts to premature wear of the engine.
Before the beginning of this operation gather all necessary tools and materials. It is necessary, that the engine was warm in order that oil flew down together with bulk of polluting substances better.
| PERFORMANCE ORDER |
|
| 1. Lift a forward part of the car and fix on supports. |
|
|
2. Unscrew a drain stopper approximately on a turn half. Place the container for oil plum under a drain stopper and unscrew a stopper completely. If it is necessary, press a stopper when unscrew that oil did not proceed prematurely. |
| 3. When oil completely will flow down, wipe everything round a drain opening a rag and reliably screw up a masloslivny stopper. |
| |
4. Establish the container for merged oil under the oil filter and, using the special tool, weaken the filter, then unscrew it a hand. |
| 5. Wipe all traces of oil and dirt round a place of fastening of the filter. Check, whether there was a rubber consolidation on the block of cylinders. If it remained, remove it. |
| 6. The oil filter screw in a hand to a contact of rubber laying with the engine, then довинтите the filter a hand on 3/4 turns. |
| 7. Establish the car on an equal horizontal surface. |
| 8. Fill in fresh engine oil through a maslonalivny mouth. |
| 9. Close a cover of a maslozalivny mouth, start the engine and let's to it work some minutes. Check it about leakages of oil round the filter and a drain stopper on the oil pallet. Keep in mind that the emergency bulb of pressure of oil can burn some seconds as oil should fill all channels and oil capacities in the engine. |
| 10. Switch off the engine and wait some minutes that oil flew down in the pallet. Check level of oil and add, if it is necessary. |
|
|
|