Toyota Camry

1992-1997 of release

Repair and car operation

Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
- 7. Ignition system
   7.2. Accumulator
   + 7.3. Ignition system
   - 7.4. Check of system of ignition
      7.4.2. Ignition system without the ignition distributor
   + 7.5. Ignition coil
   + 7.6. Ignition distributor
   7.7. Check and adjustment of a corner of an advancing of ignition
   7.8. Block ignitions (switchboard)
   + 7.9. Sensor of impulses
   7.10. Charging system
   7.11. Generator
   7.12. Check and replacement of components of the generator
   7.13. System of start of the engine
   7.14. Starter
   7.15. Traction relay
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment

7.4. Check of system of ignition

7.4.1. Ignition system with the ignition distributor

PERFORMANCE ORDER

1. If the engine is turned by a starter, but not started, remove a high-voltage wire from any candle and, using the tool with the isolated handles, place the wire end at distance of 6 mm from weight.

2. Turning the engine a starter, check that in an interval between a wire and weight the spark slips.

3. If the spark is present, means, on a spark plug tension moves. Similarly check spark presence on other cylinders.

4. In the absence of a spark and availability of moisture on a distributor cover, dry a cover and a distributor rotor, establish them on a place and repeat check.

5. Boots of natyazhitel should rotate freely on axes. If on them there are cracks, chips or considerable wear of a working surface, it is necessary to replace them.

6. If the spark still is absent, remove the central high-voltage wire from a cover of the distributor and place the wire end at distance of 6 mm from weight and repeat check.

7. If the spark appeared, means high-voltage wires to candles, a cover or a distributor rotor are faulty.

8. If the spark still is absent, check connection of primary winding of the coil of ignition and tension giving not the ignition coil from the ignition lock.

9. If the spark still is absent, check integrity of the central high-voltage wire, having measured its resistance or having replaced a wire.

10. If the spark still is absent, means the control unit ignition (switchboard) is faulty.