Toyota Camry

1992-1997 of release

Repair and car operation

Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
- 7. Ignition system
   7.2. Accumulator
   + 7.3. Ignition system
   - 7.4. Check of system of ignition
      7.4.2. Ignition system without the ignition distributor
   + 7.5. Ignition coil
   + 7.6. Ignition distributor
   7.7. Check and adjustment of a corner of an advancing of ignition
   7.8. Block ignitions (switchboard)
   + 7.9. Sensor of impulses
   7.10. Charging system
   7.11. Generator
   7.12. Check and replacement of components of the generator
   7.13. System of start of the engine
   7.14. Starter
   7.15. Traction relay
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment

7.4.2. Ignition system without the ignition distributor

PERFORMANCE ORDER

	1. Using a special tester for check of system of ignition without the distributor, connect a tester clip to weight and a high-voltage wire and turning the engine a starter, watch an electrode of a tester to define spark existence.
2. If the spark is present, means, on a spark plug tension moves. Similarly check spark presence on other cylinders.
	3. If the spark is absent or its admissions are observed, check tension on the ignition coil.
4. If the spark still is absent, check sensors the provision of distributive and cranked shaft.
	5. If the spark still is absent, check receipt of a signal from the ignition block on coils. Remove sockets from each coil and connect a light-emitting diode sampler. Turning the engine a starter, watch a sampler which should blink that testifies to receipt of signals from the ignition block to the coil.
6. If the spark still is absent, replace the ignition block.