Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
- 12. Brake system
   12.2. General information
   12.3. Anti-blocking system of brakes (ABS)
   12.4. Replacement of brake shoes of disk brakes
   + 12.5. Support of disk brakes
   + 12.6. Brake disk
   12.7. Replacement of brake shoes of drum-type brakes
   + 12.8. Working brake cylinder
   + 12.9. Main brake cylinder
   12.10. Brake pipelines and hoses
   12.11. Pumping of hydraulic brake system
   + 12.12. Vacuum amplifier of brakes
   12.13. Replacement of brake shoes of the hand brake on back disk brakes
   + 12.14. Adjustment of the parking brake
   - 12.15. Replacement of a cable of the hand brake
      12.15.2. Intermediate cable
      12.15.3. Forward cable of the hand brake
   + 12.16. Stoplight switch
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment
вакансии - Москва




12.15. Replacement of a cable of the hand brake

12.15.1. Back cable

PERFORMANCE ORDER
1. Lift a back part of the car and fix on supports. Remove the corresponding back wheel.
2. Check that the hand brake is completely released and remove a brake disk or a brake drum.
3. On models with drum-type brakes remove brake shoes and disconnect a cable of the hand brake from the lever on a brake shoe. On models with back disk brakes remove brake shoes of the hand brake and disconnect a cable of the hand brake from the lever on a back brake shoe.
4. Unscrew two bolts of fastening of a cover of a cable to a brake board.
5. Under the car unscrew bolts of all fastenings of a cable of the hand brake.
6. Remove the central exhaust pipe.
7. Unscrew tightening bolts and take forward parts of back cables of the hand brake from clips.
8. Disconnect forward parts of back cables of the hand brake from the jack.
9. Installation is made in sequence, return to removal.

10. Adjust a cable of the hand brake.