Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
- 12. Brake system
   12.2. General information
   12.3. Anti-blocking system of brakes (ABS)
   12.4. Replacement of brake shoes of disk brakes
   + 12.5. Support of disk brakes
   - 12.6. Brake disk
      12.6.2. Removal
      12.6.3. Installation
   12.7. Replacement of brake shoes of drum-type brakes
   + 12.8. Working brake cylinder
   + 12.9. Main brake cylinder
   12.10. Brake pipelines and hoses
   12.11. Pumping of hydraulic brake system
   + 12.12. Vacuum amplifier of brakes
   12.13. Replacement of brake shoes of the hand brake on back disk brakes
   + 12.14. Adjustment of the parking brake
   + 12.15. Replacement of a cable of the hand brake
   + 12.16. Stoplight switch
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment



12.6. Brake disk

12.6.1. Check

GENERAL INFORMATION

Cleaning of a working surface of a brake disk by a small emery paper
 

The minimum thickness of a brake disk is beaten out on an internal surface of a brake disk.

Measurement of thickness of a brake disk
 

PERFORMANCE ORDER
1. Lift respectively a lobby or a back part of the car and fix on supports. Remove the corresponding wheel.
2. Remove a support and, using a soft wire, adhere it to a rack, without disconnecting from it a brake hose. Establish under nuts of fastening of a wheel of a washer in thickness of 10 mm and screw nuts of fastening of a wheel. Unscrew two bolts and remove the holder of a support.
3. Slowly turn a brake disk so that it could be considered from two parties. Wear of a brake disk from blocks should be in admissible limits. If wear exceeds an admissible limit, or there are cracks on a disk, the disk is subject to replacement.
4. The indicator of hour type check palpation of a brake disk. The indicator of hour type fix in any convenient place and, turning a disk, define its palpation at distance of 10 mm from external edge.