Toyota Camry

1992-1997 of release

Repair and car operation


Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
- 12. Brake system
   12.2. General information
   12.3. Anti-blocking system of brakes (ABS)
   12.4. Replacement of brake shoes of disk brakes
   + 12.5. Support of disk brakes
   + 12.6. Brake disk
   12.7. Replacement of brake shoes of drum-type brakes
   + 12.8. Working brake cylinder
   + 12.9. Main brake cylinder
   12.10. Brake pipelines and hoses
   12.11. Pumping of hydraulic brake system
   + 12.12. Vacuum amplifier of brakes
   12.13. Replacement of brake shoes of the hand brake on back disk brakes
   + 12.14. Adjustment of the parking brake
   + 12.15. Replacement of a cable of the hand brake
   + 12.16. Stoplight switch
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment



12.4. Replacement of brake shoes of disk brakes
GENERAL INFORMATION
Preventions

Surely make replacement of all blocks on one axis of the car even if the limit of wear were reached by only one block. If blocks are repeatedly established, before removal they are necessary for marking.

At work of brake shoes the brake dust which contains asbestos, unhealthy is formed. Therefore when cleaning brake shoes do not use the compressed air and do not inhale a dust.

PERFORMANCE ORDER
1. Lift a forward part of the car and fix on supports. Remove forward wheels.
2. Using a G-shaped clip, press the piston into the support cylinder. At a piston vdviganiye brake liquid is forced out from the brake cylinder in a broad tank. Therefore constantly watch liquid level in a tank, and if necessary pump out from a tank its small amount.
3. Clear a brake disk with use of special liquid.
4. For removal of a support unscrew the bolts shown by extreme shooters. An average bolt unscrew only in case the support acts in film completely. 5. Remove a support from the holder of a support. 6. Without disconnecting from a support a brake hose, suspend a support a soft wire to a rack of a forward suspension bracket.
7. Remove the top spring of an anti-tinkling sound. 8. Remove the bottom spring of an anti-tinkling sound (model 1994 and 1995 of year). 9. Remove laying of an external brake shoe.
10. Remove internal laying of an external brake shoe. 11. Remove an external brake shoe. 12. Remove external laying of an internal brake shoe.
13. Remove internal laying of an internal brake shoe. 14. Remove an internal brake shoe. 15. Remove 4 basic plates of brake shoes, examine their condition and establish into place.

16. Remove the sensor of wear of brake shoes from an old brake shoe and establish on a new brake shoe.
 17. Establish an internal brake shoe both external and internal laying of a brake shoe. 18. Establish an external brake shoe and internal and external laying of a brake shoe.
19. Establish the top and bottom springs of an anti-tinkling sound. 20. Take the top and bottom directing fingers from the holder of a support and check their condition. 21. Put a layer high-distemper of turny greasing on directing fingers and establish them in the holder of a support.
22. Establish a support on a place and fix bolts.