Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
- 1. Maintenance
   1.2. Periodicity of service
   - 1.3. Maintenance
      + 1.3.1. Each 400 km or weekly
      + 1.3.2. Each 5 000 km or 3 months
      - 1.3.3. Each 10 000 km or 6 months
         1.3.3.1.1. Type A
         1.3.3.1.2. Type B
         1.3.3.2. Check of a free wheeling and height of installation of a pedal of coupling
         + 1.3.3.3. Check and accumulator service
         - 1.3.3.4. Check and replacement of a driving belt
            1.3.3.4.2. Adjustment
            1.3.3.4.3. Replacement
         + 1.3.3.5. Check of tightness of hoses and effluence of liquids
         1.3.3.6. Check of system of cooling
         1.3.3.7. Change of provision of installation of tires
      + 1.3.4. Each 25 000 km or 12 months
      + 1.3.5. Each 50 000 km or 24 months
      + 1.3.6. Each 100 000 km or 48 months
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment



1.3.3.4. Check and replacement of a driving belt

1.3.3.4.1. Check

GENERAL INFORMATION

Driving belts are located on the right side of the engine.

Depending on a complete set of the car and the engine established in it, some driving belts are used. One belt is used for torque transfer from a cranked shaft to the generator and the conditioner compressor. If the car is equipped by the amplifier of a steering, for a drive of the pump of the amplifier of a steering использу ется a separate belt.

PERFORMANCE ORDER
1. Open a cover closing belts, and check a condition of belts on existence of cracks, stratifications and a zamaslivaniye. If necessary replace a belt.
2. For check of a tension of a driving belt use the special Nippondenso or Burroughs tools. A tension for a belt new and being in the use differ. Being in the use it is considered a belt which worked on the engine more than 5 minutes.
3. In the absence of special tools the tension of a driving belt is necessary for adjusting so that by pressing a hand thumb on a long branch of a belt the deflection made about 5 mm if the distance between the central pulleys makes about 250 mm, or 10 mm if the distance between the central pulleys makes about 350 mm (1 – a ruler, 2 – a ruler, 3 – a belt deflection).