Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
- 1. Maintenance
   1.2. Periodicity of service
   - 1.3. Maintenance
      + 1.3.1. Each 400 km or weekly
      + 1.3.2. Each 5 000 km or 3 months
      + 1.3.3. Each 10 000 km or 6 months
      + 1.3.4. Each 25 000 km or 12 months
      - 1.3.5. Each 50 000 km or 24 months
         + 1.3.5.2. Replacement of cooling liquid
         1.3.5.3. Check of system of catching паров fuels
         1.3.5.4. Check of an exhaust system
         + 1.3.5.5. Oil replacement in an automatic transmission and the main transfer
         1.3.5.6. Oil replacement in a makhanichesky transmission
         1.3.5.7. Check of fastening of a suspension bracket
         + 1.3.5.8. Check and replacement of spark plugs
         1.3.5.9. Check and replacement of high-voltage wires and distributor details
      + 1.3.6. Each 100 000 km or 48 months
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment
вакансии - Москва



1.3.5.9. Check and replacement of high-voltage wires and distributor details

GENERAL INFORMATION

Main defect of a rotor of the distributor

PERFORMANCE ORDER
1. Check a condition of high-voltage wires which should be pure and dry, and also should not have traces of electric breakdown and oxidation.
2. Check internal state of a candle tip which should not have signs of corrosion which represents a firm white powder.

3. Unscrew two bolts and uncover the distributor. Carefully wipe a cover and check corrosion of electrodes.
4. Also check coal contact in the center of a cover of the distributor.
5. Remove a rotor of the distributor and investigate it on existence of cracks and carbonaceous paths.
6. Establish high-voltage wires on a cover of the distributor and check resistance between a tip of a high-voltage wire and a lateral electrode on a distributor cover. If resistance exceeds admissible limits, it is necessary to replace a cover of the distributor and/or a high-voltage wire.