Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
- 12. Brake system
   12.2. General information
   12.3. Anti-blocking system of brakes (ABS)
   12.4. Replacement of brake shoes of disk brakes
   - 12.5. Support of disk brakes
      12.5.1. Removal
      12.5.2. Support repair
      12.5.3. Installation
   + 12.6. Brake disk
   12.7. Replacement of brake shoes of drum-type brakes
   + 12.8. Working brake cylinder
   + 12.9. Main brake cylinder
   12.10. Brake pipelines and hoses
   12.11. Pumping of hydraulic brake system
   + 12.12. Vacuum amplifier of brakes
   12.13. Replacement of brake shoes of the hand brake on back disk brakes
   + 12.14. Adjustment of the parking brake
   + 12.15. Replacement of a cable of the hand brake
   + 12.16. Stoplight switch
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment



12.5.2. Support repair

PERFORMANCE ORDER
1. Using a small screw-driver, remove a dustproof cover from the support piston.
2. Take the piston from a support for what it is possible использо вать air under the low pressure, submitted to the brake cylinder through an opening for connection of a brake hose. Thus instead of brake shoes establish wooden whetstone.
3. Take a sealing ring from a flute in a support opening.
4. Wash out all details in methyl alcohol or pure brake liquid and wipe them.
5. Dip the piston and a new sealing ring of the piston into brake liquid and apply a thin film brake liquid on an opening for the piston in a support. Establish condense a telny ring in a support opening.
6. Establish a dustproof cover on the piston so that internal diameter of a cover was included into a piston flute. Insert the piston into a support and at the same time insert an external edge of a dustproof cover into a support before its fixing.
7. Grease with high-temperature greasing and establish directing fingers in the support case.