Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
- 1. Maintenance
   1.2. Periodicity of service
   - 1.3. Maintenance
      + 1.3.1. Each 400 km or weekly
      + 1.3.2. Each 5 000 km or 3 months
      - 1.3.3. Each 10 000 km or 6 months
         1.3.3.1.1. Type A
         1.3.3.1.2. Type B
         1.3.3.2. Check of a free wheeling and height of installation of a pedal of coupling
         + 1.3.3.3. Check and accumulator service
         + 1.3.3.4. Check and replacement of a driving belt
         - 1.3.3.5. Check of tightness of hoses and effluence of liquids
            1.3.3.5.1. Fuel hoses
            1.3.3.5.2. Unknown leakages of liquids
            1.3.3.5.3. Vacuum hoses
         1.3.3.6. Check of system of cooling
         1.3.3.7. Change of provision of installation of tires
      + 1.3.4. Each 25 000 km or 12 months
      + 1.3.5. Each 50 000 km or 24 months
      + 1.3.6. Each 100 000 km or 48 months
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment
вакансии - Москва



1.3.3.5.3. Vacuum hoses

GENERAL INFORMATION

In spite of the fact that the brake system hydraulic, the amplifier of brakes increases the effort attached to a brake pedal, using vacuum in the inlet collector, created at operation of the engine. The vacuum is transferred to the amplifier through a hose of big section. Any leakage of this hose will reduce efficiency of brake system.

Leak in a vacuum hose means that air is sucked in in a hose, instead of leaves a hose, and it does leak very difficult for detection. The method of detection consists in using an old vacuum hose, as some kind of stethoscope. Thus hold one end of a hose close to an ear, and other end use to investigate area round prospective leak. When the end of a hose will directly be over the leak place, the hissing sound will be clearly audible through an additional hose. It is necessary to avoid contact to hot and moving details as the engine at check should work. Replace all found not tight vacuum hoses.