Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
- 13. Suspension bracket
   13.2. General information
   + 13.3. Forward stabilizer of cross-section stability
   + 13.4. The lobby is resistant
   13.5. Repair of a forward rack
   + 13.6. Bottom lever of a forward suspension bracket
   13.7. Replacement of the bottom hinge of a forward suspension bracket
   + 13.8. Rotary fist
   13.9. Back stabilizer of cross-section stability
   + 13.10. Rack of a back suspension bracket
   13.11. Longitudinal draft of a back suspension bracket
   + 13.12. Levers of a back suspension bracket
   + 13.13. Nave of a back suspension bracket
   + 13.14. Fixing element of a back nave
   - 13.15. Steering wheel
      13.15.2. Installation
   + 13.16. Tips of steering draft
   13.17. Replacement of protective covers of steering transfer
   + 13.18. Steering transfer
   + 13.19. Pump of the amplifier of a steering
   13.20. Air removal from steering system with the amplifier
   + 13.21. Wheels and tires
   13.22. Corners of installation of wheels
+ 14. Body
+ 15. Electric equipment



13.15. Steering wheel

13.15.1. Removal

GENERAL INFORMATION

Preventions

At existence in a code radio receiver against theft, before an accumulator detachment, check that you have connection codes.

On models since 1993 the system of an airbag of safety is disconnected, if the accumulator is disconnected for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for restoration of operability of system.

Further actions make not earlier than in 90 seconds that the condenser of an airbag was discharged completely.


PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. Establish forward wheels for movement directly forward. From two parties of a steering wheel remove caps and unscrew on two screws of fastening of a safety cushion to a steering wheel.
3. Take the safety cushion block from a steering wheel and disconnect from the block the electric socket.
4. Disconnect the electric socket of a sound signal and system cruise control.
5. Note the provision of a nave of a steering wheel in relation to a steering shaft and unscrew a nut of fastening of a steering wheel.
6. Using a special stripper, remove a steering wheel from a shaft.