Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
- 13. Suspension bracket
   13.2. General information
   + 13.3. Forward stabilizer of cross-section stability
   + 13.4. The lobby is resistant
   13.5. Repair of a forward rack
   + 13.6. Bottom lever of a forward suspension bracket
   13.7. Replacement of the bottom hinge of a forward suspension bracket
   + 13.8. Rotary fist
   13.9. Back stabilizer of cross-section stability
   + 13.10. Rack of a back suspension bracket
   13.11. Longitudinal draft of a back suspension bracket
   + 13.12. Levers of a back suspension bracket
   + 13.13. Nave of a back suspension bracket
   + 13.14. Fixing element of a back nave
   + 13.15. Steering wheel
   + 13.16. Tips of steering draft
   13.17. Replacement of protective covers of steering transfer
   - 13.18. Steering transfer
      13.18.2. Installation
   + 13.19. Pump of the amplifier of a steering
   13.20. Air removal from steering system with the amplifier
   + 13.21. Wheels and tires
   13.22. Corners of installation of wheels
+ 14. Body
+ 15. Electric equipment
вакансии - Москва




13.18. Steering transfer

13.18.1. Removal

GENERAL INFORMATION

Elements of fastening of steering transfer
 
1–шплинт;
2–protection of the right forward wing;
3–stabilizer of cross-section stability;
4–protection of the left forward wing;
5–шплинт

PERFORMANCE ORDER
1. Establish forward wheels for movement directly forward. Lift a forward part of the car and fix on supports. Remove wheels. Remove an engine mudguard.

2. Establish under steering transfer the corresponding container and disconnect from the steering transfer, submitting and returnable tubes and close them jams.
3. Note mutual position of the bottom universal hinge and an entrance shaft of steering transfer. Unscrew bottom tightening a bolt of an intermediate shaft.
4. Remove spherical hinges of tips of steering draft from rotary fists.
5. Unscrew bolts of fastening of plugs of the stabilizer of cross-section stability.
6. Unscrew nuts of fastening of steering transfer, raise the stabilizer of cross-section stability and take bolts of fastening of steering transfer.
7. Remove an intermediate shaft from an entrance shaft of steering transfer and take steering transfer from the right side of the car.