Toyota Camry

1992-1997 of release

Repair and car operation

Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
- 15. Electric equipment
   15.2. General information
   15.3. Electric chains
   + 15.4. Detection of not closed chain
   15.5. Safety locks
   15.6. Relay
   + 15.7. Multipurpose switches of a steering column
   + 15.8. Ignition lock
   15.9. Switch of a heater of back glass
   15.10. Check of a heater of back glass
   15.11. Radio receiver
   15.12. Loudspeakers
   15.13. Aerial
   15.14. Replacement of bulbs of headlights
   15.15. Adjustment of light of headlights
   15.16. Headlight
   + 15.17. Replacement of bulbs of an incandescence
   + 15.18. Screen wiper engine
   15.19. Combination of devices
   15.20. Sound signal
   15.21. System cruise control
   15.22. Window regulators with an electric drive
   15.23. System of the central blocking of locks
   15.24. Rear-view mirrors with the electric drive
   15.25. Safety airbag
   + 15.26. Electric equipment schemes

15.10. Check of a heater of back glass

GENERAL INFORMATION

The heater of back glass represents a set of the horizontal conductors which have been raised dust on an internal surface of back glass.

PERFORMANCE ORDER

1. For detection of a rupture of the conductor of a heater of back glass include ignition and the switch of a heater of back glass.
	2. Connect one щуп the voltmeter to mass of the car, and the second щуп wrap up a foil and move a foil on the heater conductor.
	3. Connect щуп the voltmeter in the center of each conductor of a heater of back glass. If the voltmeter shows tension about 5 In, the conductor of a heater means is serviceable. If the voltmeter shows tension 0 In or 12 In, means there is a rupture of the conductor of a heater.
	4. For detection of a place of a rupture of the conductor of a heater connect one щуп the voltmeter to the positive plug of a heater, and the second щуп move on the heater conductor from the negative plug of a heater. The point in which the tension shown by the voltmeter, will fall from several volts to zero and is a place of a rupture of the conductor of a heater.