1992-1997 of release
Repair and car operation
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
- 15. Electric equipment
15.2. General information
15.3. Electric chains
+ 15.4. Detection of not closed chain
15.5. Safety locks
+ 15.7. Multipurpose switches of a steering column
+ 15.8. Ignition lock
15.9. Switch of a heater of back glass
15.10. Check of a heater of back glass
15.11. Radio receiver
15.14. Replacement of bulbs of headlights
15.15. Adjustment of light of headlights
+ 15.17. Replacement of bulbs of an incandescence
+ 15.18. Screen wiper engine
15.19. Combination of devices
15.20. Sound signal
15.21. System cruise control
15.22. Window regulators with an electric drive
15.23. System of the central blocking of locks
15.24. Rear-view mirrors with the electric drive
15.25. Safety airbag
+ 15.26. Electric equipment schemes
Arrangement of elements of management of external rear-view mirrors with the electric drive
Removal of the switch of adjustment of provision of an external mirror
Use of a digital ohmmeter for check of a condition of contacts of the switch of a mirror
The switch of adjustment of provision of a mirror and condition of contacts at various positions of the switch
For management of the provision of an external rear-view mirror it is used in each mirror on two electric motors.
Adjustment of provision of an external rear-view mirror with the electric drive is possible only after ignition inclusion.
For check of operability of the engine, turn on the switch and listen, whether there is a sound of the working engine.
If the engine works, but the mirror does not move, possibly, there is a defect of a drive in a mirror.
If the mirror does not move and the engine does not work, check a safety lock in the block of safety locks located on the left side under the dashboard.
If a safety lock whole, remove a decorative overlay of a combination of devices for access to a back part of the switch of mirrors. Without disconnecting the electric socket from the switch, include ignition and check tension on the switch. Tension should be present on one contact of the socket. If tension is absent, check an electric chain between the block of safety locks and the switch.
If tension moves to the switch, disconnect from it the electric socket and check serviceability of the switch (see fig. Removal of the switch of adjustment of provision of an external mirror, fig. Use of a digital ohmmeter for check of a condition of contacts of the switch of a mirror, fig. The switch of adjustment of provision of a mirror and a condition of contacts at various positions of the switch).