Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
- 15. Electric equipment
   15.2. General information
   15.3. Electric chains
   + 15.4. Detection of not closed chain
   15.5. Safety locks
   15.6. Relay
   + 15.7. Multipurpose switches of a steering column
   + 15.8. Ignition lock
   15.9. Switch of a heater of back glass
   15.10. Check of a heater of back glass
   15.11. Radio receiver
   15.12. Loudspeakers
   15.13. Aerial
   15.14. Replacement of bulbs of headlights
   15.15. Adjustment of light of headlights
   15.16. Headlight
   + 15.17. Replacement of bulbs of an incandescence
   + 15.18. Screen wiper engine
   15.19. Combination of devices
   15.20. Sound signal
   15.21. System cruise control
   15.22. Window regulators with an electric drive
   15.23. System of the central blocking of locks
   15.24. Rear-view mirrors with the electric drive
   15.25. Safety airbag
   + 15.26. Electric equipment schemes



15.11. Radio receiver

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
Preventions

At existence in a code radio receiver against theft, before a detachment of the accumulator check that you have connection codes.

On models since 1993 the system of an airbag of safety is disconnected, if the accumulator is disconnected for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for restoration of operability of system.


2. Remove the decorative panel located round a radio receiver.
3. Unscrew screws of fastening of a radio receiver.
4. Extend a radio receiver from a nest, disconnect from it the electric socket and the aerial and take a radio receiver from the car.
5. Installation is made in sequence, return to removal.