Toyota Camry

1992-1997 of release

Repair and car operation

Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
- 5. Cooling and heating
   5.2. General information
   5.3. Antifreeze
   5.4. Hoses of system of cooling
   + 5.5. Check and thermostat replacement
   + 5.6. Check and replacement of the fan of a radiator and relay
   + 5.7. The radiator fan (the V6 models from 1992 to 1994)
   + 5.8. Radiator
   5.9. Broad tank
   + 5.10. Water pump
   + 5.11. The sensor of temperature of cooling liquid
   5.12. Heater fan
   5.13. Resistor of the fan of a heater
   5.14. Heater radiator
   + 5.15. Control panel heater
   5.16. Air central air
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment

5.12. Heater fan

1. Remove a weight wire from the accumulator.
2. The fan is located on the right side under the dashboard.
3. Remove a ware box, a cover of a ware box and the bottom furnish of the panel under a ware box.
4. Disconnect from the engine of the fan of a heater электричес a cue the socket and on contacts of the engine submit additional wires tension from the accumulator. If the engine does not work, replace the engine.
5. If the engine works, connect additional wires to the fan socket a bulb. Include ignition, turn the handle of turning on of the fan and check поступле tension scientific research institute to the socket.
6. For removal of the fan unscrew screws and lower the heater fan down. On models with engines 1MZ-FE unscrew two screws and disconnect electric sockets of a plait of wires for simplification of access to the fan.
7. Installation is made in sequence, return to removal.