Repair and Toyota Camry car operation - 5.11. The sensor of temperature of cooling liquid//Kamri's Toyota of 1992-1997 / frndl.ru

Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
- 5. Cooling and heating
   5.2. General information
   5.3. Antifreeze
   5.4. Hoses of system of cooling
   + 5.5. Check and thermostat replacement
   + 5.6. Check and replacement of the fan of a radiator and relay
   + 5.7. The radiator fan (the V6 models from 1992 to 1994)
   + 5.8. Radiator
   5.9. Broad tank
   + 5.10. Water pump
   - 5.11. The sensor of temperature of cooling liquid
      5.11.2. Replacement
   5.12. Heater fan
   5.13. Resistor of the fan of a heater
   5.14. Heater radiator
   + 5.15. Control panel heater
   5.16. Air central air
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment
вакансии - Москва



5.11. The sensor of temperature of cooling liquid

5.11.1. Check

GENERAL INFORMATION

Arrangement of the sensor of temperature of cooling liquid on the four-cylinder engine

Arrangement of the sensor of temperature of cooling liquid on the engine of 1 MZ-FE

PERFORMANCE ORDER
1. If the index of temperature does not work, check fuses in an electric chain.

2. If the index of temperature shows high температу ру at start of the cold engine, disconnect a wire from the temperature sensor (see fig. An arrangement of the sensor of temperature of cooling liquid on the four-cylinder engine). If the index of temperature shows low temperature of the engine, replace the sensor of temperature of cooling liquid. If the index still shows high temperature, check a condition of an electric chain from the sensor to the index or the index of temperature of cooling liquid.

3. If the index of temperature of cooling liquid does not show any temperature after warming up of the engine and a safety lock in a normal state, disconnect a wire from the sensor of temperature and connect it to mass of the car. For short time include ignition, without starting the engine. If the index of temperature shows high temperature of the engine, replace the sensor of temperature of cooling liquid. If the arrow of the index remains on a place, check a condition of an electric chain or serviceability of the index of temperature of cooling liquid.