Toyota Camry

1992-1997 of release

Repair and car operation

Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
- 5. Cooling and heating
   5.2. General information
   5.3. Antifreeze
   5.4. Hoses of system of cooling
   + 5.5. Check and thermostat replacement
   + 5.6. Check and replacement of the fan of a radiator and relay
   + 5.7. The radiator fan (the V6 models from 1992 to 1994)
   + 5.8. Radiator
   5.9. Broad tank
   - 5.10. Water pump
      5.10.2. Models with V6 engines
   + 5.11. The sensor of temperature of cooling liquid
   5.12. Heater fan
   5.13. Resistor of the fan of a heater
   5.14. Heater radiator
   + 5.15. Control panel heater
   5.16. Air central air
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment

5.10. Water pump

5.10.1. Models with four-cylinder engines

GENERAL INFORMATION

Arrangement of a bolt of fastening of adjusting draft of the generator

PERFORMANCE ORDER

1. Remove a weight wire from the accumulator. Preventions At existence in a code radio receiver against theft, before a detachment of the accumulator check that you have connection codes. On models since 1993 the system of an airbag of safety is disconnected, if the accumulator is disconnected for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for restoration of operability of system.
2. Remove a gear belt and single pulleys.
3. Unscrew adjusting draft of the generator (see fig. Arrangement of a bolt of fastening of adjusting draft of the generator).
4. Unscrew bolts of fastening of the water pump and remove the pump together with laying.
	5. Disconnect bypass a hose of system of cooling from a branch pipe, unscrew two nuts of fastening of a branch pipe of supply of cooling liquid to a heater and uncover the pump.
6. Clear all interfaced surfaces of the water pump.

7. Establish the water pump with new laying on the block of cylinders and fix bolts in the sequence shown in drawings.
	8. Establish new laying on the thermostat.
9. Further installation is made in sequence, return to removal.