Repair and Toyota Camry car operation - 5.5. Check and thermostat replacement//Kamri's Toyota of 1992-1997 / frndl.ru

Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
- 5. Cooling and heating
   5.2. General information
   5.3. Antifreeze
   5.4. Hoses of system of cooling
   - 5.5. Check and thermostat replacement
      5.5.2. Replacement
   + 5.6. Check and replacement of the fan of a radiator and relay
   + 5.7. The radiator fan (the V6 models from 1992 to 1994)
   + 5.8. Radiator
   5.9. Broad tank
   + 5.10. Water pump
   + 5.11. The sensor of temperature of cooling liquid
   5.12. Heater fan
   5.13. Resistor of the fan of a heater
   5.14. Heater radiator
   + 5.15. Control panel heater
   5.16. Air central air
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment
вакансии - Москва



5.5. Check and thermostat replacement

5.5.1. Check

GENERAL INFORMATION

In the presence of defects in system of cooling check level of cooling liquid and operability of the index of temperature.

PERFORMANCE ORDER
1. If after start the engine gets warm very slowly, that, probably, the thermostat is in constantly open situation, and it is necessary to replace it.
2. If the engine overheats, a hand check температу ру the top hose of a radiator. If the hose cold, that, probably, the thermostat is in a closed position and does not pass cooling liquid to a radiator. In this case the thermostat also is subject to replacement.
3. If the thermostat is in open situation at room temperature, it is subject to replacement.
4. For check of the thermostat lower it on a twine in the container with water. Gradually heating up water, notice temperature at which the thermostat starts to open and completely will open. Take the thermostat from water and check, that it was completely closed after cooling. Replace the thermostat if its parameters differ from technical requirements.