Toyota Camry

1992-1997 of release

Repair and car operation


Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
- 5. Cooling and heating
   5.2. General information
   5.3. Antifreeze
   5.4. Hoses of system of cooling
   + 5.5. Check and thermostat replacement
   + 5.6. Check and replacement of the fan of a radiator and relay
   + 5.7. The radiator fan (the V6 models from 1992 to 1994)
   + 5.8. Radiator
   5.9. Broad tank
   + 5.10. Water pump
   + 5.11. The sensor of temperature of cooling liquid
   5.12. Heater fan
   5.13. Resistor of the fan of a heater
   5.14. Heater radiator
   + 5.15. Control panel heater
   5.16. Air central air
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment



5.14. Heater radiator
PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
Preventions

At existence in a code radio receiver against theft, before a detachment of the accumulator check that you have connection codes.

On models since 1993 the system of an airbag of safety is disconnected, if the accumulator is disconnected for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for restoration of operability of system.
2. Merge cooling liquid from cooling system.
Working in a motor compartment, disconnect hoses of supply of cooling liquid to a heater.
3. Unscrew a heater carpet from the driver.
4. Release two brackets and remove a protective plate of a heater. 5. Unscrew three screws, remove clips and remove tubes of supply of cooling liquid to a heater radiator.
6. Take a heater radiator from a nest.
7. Installation is made in sequence, return to removal. Fill in cooling liquid in cooling system.