Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
- 15. Electric equipment
   15.2. General information
   15.3. Electric chains
   + 15.4. Detection of not closed chain
   15.5. Safety locks
   15.6. Relay
   - 15.7. Multipurpose switches of a steering column
      15.7.2. Replacement
   + 15.8. Ignition lock
   15.9. Switch of a heater of back glass
   15.10. Check of a heater of back glass
   15.11. Radio receiver
   15.12. Loudspeakers
   15.13. Aerial
   15.14. Replacement of bulbs of headlights
   15.15. Adjustment of light of headlights
   15.16. Headlight
   + 15.17. Replacement of bulbs of an incandescence
   + 15.18. Screen wiper engine
   15.19. Combination of devices
   15.20. Sound signal
   15.21. System cruise control
   15.22. Window regulators with an electric drive
   15.23. System of the central blocking of locks
   15.24. Rear-view mirrors with the electric drive
   15.25. Safety airbag
   + 15.26. Electric equipment schemes
вакансии - Москва



15.7.2. Replacement

GENERAL INFORMATION

Multipurpose switches of a steering column
1–casing of a plait of wires;
2–fastening bracket;
3–ball;
4–spring;
5–switch handle;
6–lighting switch;
7–basis of switches;
8–screen wiper switch;
9–knot of a spiral drive

PERFORMANCE ORDER
1. Remove a steering wheel.
2. Unscrew screws of fastening of the multipurpose switch.
3. Release clamps and remove the switch together with a plait of wires from a steering column.
4. Unscrew screws of fastening and remove a tel demanded a rekey from the basis of switches (see fig. Multipurpose switches of a steering column).
5. Take contacts of wires of the replaced switch and the socket. From a forward part of the socket insert a thin narrow screw-driver and wring out a fixing short mustache on contact and for a wire take contact from the socket.
6. From a back part of the socket insert contacts of a new rekey of a tel into the socket and move them before accurate fixing.
7. Further installation is made in sequence, return to removal.