Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
- 1. Maintenance
   1.2. Periodicity of service
   - 1.3. Maintenance
      + 1.3.1. Each 400 km or weekly
      + 1.3.2. Each 5 000 km or 3 months
      + 1.3.3. Each 10 000 km or 6 months
      + 1.3.4. Each 25 000 km or 12 months
      - 1.3.5. Each 50 000 km or 24 months
         - 1.3.5.2. Replacement of cooling liquid
            1.3.5.2.1. Plums of cooling liquid
            1.3.5.2.2. Washing of system of cooling
            1.3.5.2.3. Filling of system of cooling
         1.3.5.3. Check of system of catching паров fuels
         1.3.5.4. Check of an exhaust system
         + 1.3.5.5. Oil replacement in an automatic transmission and the main transfer
         1.3.5.6. Oil replacement in a makhanichesky transmission
         1.3.5.7. Check of fastening of a suspension bracket
         + 1.3.5.8. Check and replacement of spark plugs
         1.3.5.9. Check and replacement of high-voltage wires and distributor details
      + 1.3.6. Each 100 000 km or 48 months
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment



1.3.5.2.3. Filling of system of cooling

GENERAL INFORMATION

Before filling of system of cooling make sure that all hoses and collars in a good condition. Pay attention that the mix of antifreeze should be used all the year round for corrosion prevention. Also check, that a stopper on a radiator and drain jams of the block of cylinders were established into place.

PERFORMANCE ORDER

1. Establish the handle of adjustment of a heater in the provision of the maximum temperature.

2. Slowly fill in cooling liquid in a radiator.

3. Without closing a radiator stopper, start the engine and warm up it to working temperature at which the thermostat and cooling liquid will open will start to proceed through a radiator, thus the top hose of a radiator becomes hot.
4. Switch off and cool the engine, check level of cooling liquid and, if necessary, finish it to norm.
5. Compressing the top hose of a radiator, remove air from system of cooling of the engine then add cooling liquid to demanded level. Establish a radiator stopper into place.
6. Start the engine and warm up it to normal working temperature and check tightness of system of cooling of the engine.