Toyota Camry

1992-1997 of release

Repair and car operation


Kamri's Toyota
+ General data
+ 1. Maintenance
- 2. Engine
   2.2. Operations on engine repair on the car
   2.3. Top dead point of the first cylinder
   + 2.4. Cover of a head of the block of cylinders
   + 2.5. Inlet collector
   + 2.6. Final collector
   + 2.7. Gear belt and pulleys
   2.8. Replacement of a forward sealing ring of a cranked shaft
   2.9. Replacement of a sealing ring of a camshaft
   + 2.10. Camshaft and pushers
   + 2.11. Head of the block of cylinders
   + 2.12. Oil pallet
   + 2.13. Oil pump
   + 2.14. Drive flywheel / plate
   2.15. Replacement of a back sealing ring of a cranked shaft
   + 2.16. Suspension bracket of the power unit
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment



2.15. Replacement of a back sealing ring of a cranked shaft
PERFORMANCE ORDER
1. Remove a transmission and a flywheel.

2. The simplest way of extraction old uplotnitelno го rings consists in that a screw-driver to hook on a sealing ring and to take it from a nest.
3. Also sealing ring can be taken from a nest if to drill in a ring two small openings, located in the opposite ends of a sealing ring. Screw in two self-cutting screws in the drilled openings of a sealing ring and, using flat-nose pliers, extend for heads of screws a sealing ring.
4. The most reliable method of replacement of a back sealing ring of a cranked shaft is that it is necessary to remove the oil pallet and a back cover of a cranked shaft together with a sealing ring.

5. Establish a back cover of a cranked shaft together with condense with a telny ring on wooden whetstones and, using a hammer and a screw-driver, beat out an old sealing ring from a cover.
6. Using wooden whetstone and a hammer, establish a new sealing ring of a cranked shaft in a back cover.
7. Clear interfaced surfaces of the block of cylinders and a back cover of a cranked shaft and establish new laying on the block of cylinders.
8. Being careful, establish a back cover with condense with a telny ring on the engine.
9. Fix a back cover of a cranked shaft bolts, having tightened them the demanded moment, thus the bottom edge of a back cover should be flush with bottom edge of the block of cylinders of the engine.

10. Further installation is made in sequence, return to removal.