Toyota Camry

1992-1997 of release

Repair and car operation

Kamri's Toyota
+ General data
+ 1. Maintenance
- 2. Engine
   2.2. Operations on engine repair on the car
   2.3. Top dead point of the first cylinder
   + 2.4. Cover of a head of the block of cylinders
   - 2.5. Inlet collector
      2.5.2. Installation
   + 2.6. Final collector
   + 2.7. Gear belt and pulleys
   2.8. Replacement of a forward sealing ring of a cranked shaft
   2.9. Replacement of a sealing ring of a camshaft
   + 2.10. Camshaft and pushers
   + 2.11. Head of the block of cylinders
   + 2.12. Oil pallet
   + 2.13. Oil pump
   + 2.14. Drive flywheel / plate
   2.15. Replacement of a back sealing ring of a cranked shaft
   + 2.16. Suspension bracket of the power unit
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment

2.5. Inlet collector

2.5.1. Removal

GENERAL INFORMATION

Preventions

At existence in a code radio receiver against theft, before an accumulator detachment, check that you have connection codes.

On models since 1993 the system of an airbag of safety is disconnected, if the accumulator is disconnected for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for restoration of operability of system.

PERFORMANCE ORDER

1. Remove a weight wire from the accumulator.
2. Merge cooling liquid from cooling system.
3. Weaken a collar of fastening of a hose of the air filter to the case of a throttle and remove the top part of a casing of the air filter.
	4. Mark wires, hoses and a cable connecting an inlet collector with other units of the engine.
	5. Being careful, remove a plait of wires from an inlet collector.
6. Remove all thermal protection and arms and unscrew bolts of fastening of an inlet collector to a head of the block of cylinders.
7. Remove an inlet collector from the engine.