Toyota Camry

1992-1997 of release

Repair and car operation


Kamri's Toyota
+ General data
+ 1. Maintenance
- 2. Engine
   2.2. Operations on engine repair on the car
   2.3. Top dead point of the first cylinder
   + 2.4. Cover of a head of the block of cylinders
   + 2.5. Inlet collector
   + 2.6. Final collector
   + 2.7. Gear belt and pulleys
   2.8. Replacement of a forward sealing ring of a cranked shaft
   2.9. Replacement of a sealing ring of a camshaft
   + 2.10. Camshaft and pushers
   - 2.11. Head of the block of cylinders
      2.11.2. Installation
   + 2.12. Oil pallet
   + 2.13. Oil pump
   + 2.14. Drive flywheel / plate
   2.15. Replacement of a back sealing ring of a cranked shaft
   + 2.16. Suspension bracket of the power unit
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment



2.11. Head of the block of cylinders

2.11.1. Removal
GENERAL INFORMATION
Preventions

Removal of a head of the block of cylinders is necessary for making on the cold engine.

At existence in a code radio receiver against theft, before an accumulator detachment, check that you have connection codes.

On models since 1993 the system of an airbag of safety is disconnected, if the accumulator отсоеди няется for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeatedly го accumulator connections, it is necessary to address in a specialized workshop for restoration работоспо system sobnost.

PERFORMANCE ORDER

1. Remove a weight wire from the accumulator.

2. Merge cooling liquid from the block of cylinders and a radiator.

3. Merge engine oil and remove the oil filter.
4. Remove the throttle case, fuel nozzles and the fuel highway.
5. Remove an inlet collector.
6. Remove a final collector.
7. Remove a gear belt, a pulley of a camshaft and the top single pulley.
8. Remove a back casing of a gear belt.
9. Remove camshafts and pushers.
10. Remove the generator and the ignition distributor.
11. Unscrew a bolt of fastening of the pump of the amplifier of a steering and move it aside, without disconnecting from it hoses.
12. Mark and disconnect the remained pipes, hoses, cables and wires.
13. Working in sequence, return shown in drawing, weaken bolts of fastening of a head of the block of cylinders on 1/3 turns for each pass before complete unscrewing of bolts.
14. Remove a head of the block of cylinders.