Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
+ 1. Maintenance
- 2. Engine
   2.2. Operations on engine repair on the car
   2.3. Top dead point of the first cylinder
   + 2.4. Cover of a head of the block of cylinders
   + 2.5. Inlet collector
   + 2.6. Final collector
   + 2.7. Gear belt and pulleys
   2.8. Replacement of a forward sealing ring of a cranked shaft
   2.9. Replacement of a sealing ring of a camshaft
   + 2.10. Camshaft and pushers
   + 2.11. Head of the block of cylinders
   + 2.12. Oil pallet
   + 2.13. Oil pump
   + 2.14. Drive flywheel / plate
   2.15. Replacement of a back sealing ring of a cranked shaft
   + 2.16. Suspension bracket of the power unit
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment



2.2. Operations on engine repair on the car

GENERAL INFORMATION

Many repair work on the engine can be carried out directly on the car. Prior to the beginning of repair work it is recommended to clear the engine and a motor compartment carefully. Depending on a type of works it is possible to remove a cowl for simplification of access to the engine.

Without removing the engine from the car it is possible to eliminate different types of leaks, for example, to replace laying of inlet and final collectors, laying of the oil pallet, sealing rings of a cranked shaft, laying of a head of the block of cylinders and so on.

External details and units, such as inlet and final collectors, the oil pallet, the oil pump, the water pump, a starter, the generator, the distributor of ignition and elements of fuel system can be removed from the engine for repair.

As the head of the block of cylinders can be removed without dismantle of all engine from the car, and repair of the mechanism of a gazoraspredeleniye can be made without superfluous operations. In exceptional cases without removing the engine from the car replacement of piston rings, pistons, rods and loose leaves of radical and shatunny bearings is possible.