Toyota Camry

1992-1997 of release

Repair and car operation

Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
- 6. Fuel system
   6.2. General information
   6.3. Pressure removal in fuel system
   + 6.4. Check of the fuel pump
   6.5. Fuel pump
   + 6.6. Fuel level sensor
   6.7. Fuel tank
   6.8. Air filter
   + 6.9. Accelerator cable
   6.10. Electronic system of injection of EFL fuel
   + 6.11. Fuel system
   6.12. Check of system of injection of fuel
   + 6.13. Check and replacement of elements of system of injection of EFI fuel
   6.14. Fuel highway and fuel nozzles
   + 6.15. Valve of a mode of idling of central air of air
   6.16. Air inlet chamber (only V6 engines)
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment

6.12. Check of system of injection of fuel

GENERAL INFORMATION

Places of possible adjournment of a carbonaceous raid in the throttle case

If there was a malfunction in fuel system, at first check that all electric sockets are reliably connected and protected from corrosion. Also check, purity of the air filter, a condition and a gap in spark plugs, correctness of adjustment of klapanny gaps, a compression in engine cylinders, installation of a corner of an advancing of ignition and purity of hoses of supply of air in the engine.

PERFORMANCE ORDER

	1. Lift the receiver an air inlet from the case of a throttle and check existence of a carbonaceous raid in the throttle case (see fig. Places of possible adjournment of a carbonaceous raid in the throttle case). If necessary, using aerosol solvent, clear a carbonaceous raid.
	2. Using a stethoscope, check work of fuel nozzles on presence of clicks at nozzle work.
	3. If there is a suspicion that the fuel nozzle does not work, connect to contacts of a fuel nozzle a light-emitting diode sampler and at operation of the engine check that the light-emitting diode sampler blinks.
	4. Remove from a fuel nozzle the electric socket and check resistance of a fuel nozzle which should make 13,4–14,2 Ohm.
5. If primary actions do not help to reveal неисправ a nost of fuel system, it is necessary to make check and repair of fuel system at service station.