Toyota Camry

1992-1997 of release

Repair and car operation

Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
- 6. Fuel system
   6.2. General information
   6.3. Pressure removal in fuel system
   + 6.4. Check of the fuel pump
   6.5. Fuel pump
   + 6.6. Fuel level sensor
   6.7. Fuel tank
   6.8. Air filter
   + 6.9. Accelerator cable
   6.10. Electronic system of injection of EFL fuel
   + 6.11. Fuel system
   6.12. Check of system of injection of fuel
   + 6.13. Check and replacement of elements of system of injection of EFI fuel
   6.14. Fuel highway and fuel nozzles
   + 6.15. Valve of a mode of idling of central air of air
   6.16. Air inlet chamber (only V6 engines)
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment

6.5. Fuel pump

1. Uncover a toplivozalivny mouth.
2. Remove a weight wire from the accumulator.

At existence in a code radio receiver against theft, before a detachment of the accumulator check that you have connection codes.

On models since 1993 the system of an airbag of safety is disconnected, if the accumulator is disconnected for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for restoration of operability of system.

3. Remove a back seat.
4. For access to a fuel tank unscrew screws and remove a protective cover.
5. Disconnect the electric socket and топливопроводы.
6. Unscrew bolts of fastening of a cover of the fuel pump.
7. Take the fuel pump from a fuel tank.
8. Take the lower part of the fuel pump from a suspension bracket.
9. Remove rubber laying from the lower part of the fuel pump.
10. Remove a bracket, fixing a toplivozabornik to the fuel pump.
11. Remove a toplivozabornik and check his condition.
12. If replacement of the fuel pump is made, weaken a collar and remove a pressure head hose from the fuel pump.
13. Disconnect wires from the fuel pump and remove the pump.
14. Installation is made in sequence, return to removal.