Toyota Camry

1992-1997 of release

Repair and car operation


Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
- 6. Fuel system
   6.2. General information
   6.3. Pressure removal in fuel system
   + 6.4. Check of the fuel pump
   6.5. Fuel pump
   + 6.6. Fuel level sensor
   6.7. Fuel tank
   6.8. Air filter
   + 6.9. Accelerator cable
   6.10. Electronic system of injection of EFL fuel
   + 6.11. Fuel system
   6.12. Check of system of injection of fuel
   + 6.13. Check and replacement of elements of system of injection of EFI fuel
   6.14. Fuel highway and fuel nozzles
   + 6.15. Valve of a mode of idling of central air of air
   6.16. Air inlet chamber (only V6 engines)
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment



6.7. Fuel tank
GENERAL INFORMATION

Fuel tank

1–fastening belt;
2–fuel tank;
3–fuel tube of EVAP;
4–pressure head топливопровод;
5–branch pipe;
6–laying;
7–laying;
8–fuel hose;
9–installation label;
10-arm;

11-toplivozalivny mouth;
12-cover;
13-laying;
14-toplivozalivny pipe;
15-arm;
16-protective casing;
17-thermofilter;
18-central exhaust pipe;
19-arrangement of laying of a fuel tank

Typical connection of the fuel pipeline with a fuel hose

At removal of a fuel tank fuel level in it should be minimum.

PERFORMANCE ORDER
1. Uncover a jellied mouth of a fuel tank.
2. Remove a weight wire from the accumulator.
Preventions

At existence in a code radio receiver against theft, before a detachment of the accumulator check that you have connection codes.

On models since 1993 the system of an airbag of safety is disconnected, if the accumulator is disconnected for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for restoration of operability of system.
3. Lift the car on the lift or establish over a viewing hole.
4. Support a fuel tank a jack, having laid between a jack and a fuel tank a board.
5. Remove the central exhaust pipe.
6. Disconnect топливопроводы from a fuel tank and close them jams.
7. Supporting a fuel tank, unscrew the bolts, fixing two belts of fastening of a fuel tank.
8. Slowly lower a fuel tank, disconnect from it the remained tubes and the electric socket and take a fuel tank from under the car.
9. Visually check a condition of a fuel tank outside and inside. If in a fuel tank there are pollution or a precipitation, wash up it pure water or gasoline.
Prevention

At work with a fuel tank do not use open fire or tools, at work with which there can be a spark.

10. Installation is made in sequence, return to removal taking into account the next moments:
– at installation of a fuel tank in the car check, that any of hoses was not pressed;
– check, that all pipes and hoses were correctly connected and reliably fixed;
– fill in in a fuel tank a small amount of fuel and check fuel system on tightness.