Toyota Camry

1992-1997 of release

Repair and car operation

Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
- 6. Fuel system
   6.2. General information
   6.3. Pressure removal in fuel system
   + 6.4. Check of the fuel pump
   6.5. Fuel pump
   + 6.6. Fuel level sensor
   6.7. Fuel tank
   6.8. Air filter
   + 6.9. Accelerator cable
   6.10. Electronic system of injection of EFL fuel
   + 6.11. Fuel system
   6.12. Check of system of injection of fuel
   + 6.13. Check and replacement of elements of system of injection of EFI fuel
   6.14. Fuel highway and fuel nozzles
   + 6.15. Valve of a mode of idling of central air of air
   6.16. Air inlet chamber (only V6 engines)
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment

6.14. Fuel highway and fuel nozzles

6.14.1. Replacement

GENERAL INFORMATION

Arrangement of screws of fastening of the switching vacuum valve

PERFORMANCE ORDER

1. Remove pressure in fuel system.
2. Remove a weight wire from the accumulator. Preventions At existence in a code radio receiver against theft, before a detachment of the accumulator check that you have connection codes. On models since 1993 the system of an airbag of safety is disconnected, if the accumulator is disconnected for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for restoration of operability of system.
3. Remove PCV hose from a head of the block of cylinders and an inlet collector.
	4. Unscrew screws of fastening of the switching vacuum valve (VSP) and move the valve aside.
5. Disconnect from fuel nozzles electric sockets and move a plait of wires with sockets aside.
6. Disconnect a vacuum hose from a regulator of pressure of fuel.

7. Disconnect топливопроводы from a regulator of pressure of fuel and the fuel highway.	8. For access to bolts of fastening of the back fuel highway it is necessary to remove the air inlet chamber previously.	9. Unscrew bolts of fastening of the fuel highway.

10. Remove the fuel highway together with fuel nozzles.	11. Remove fuel nozzles from the fuel highway.	12. At installation of fuel nozzles use new sealing rings.
13. Installation is made in sequence, return to removal.