Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
- 13. Suspension bracket
   13.2. General information
   + 13.3. Forward stabilizer of cross-section stability
   + 13.4. The lobby is resistant
   13.5. Repair of a forward rack
   + 13.6. Bottom lever of a forward suspension bracket
   13.7. Replacement of the bottom hinge of a forward suspension bracket
   + 13.8. Rotary fist
   13.9. Back stabilizer of cross-section stability
   + 13.10. Rack of a back suspension bracket
   13.11. Longitudinal draft of a back suspension bracket
   + 13.12. Levers of a back suspension bracket
   + 13.13. Nave of a back suspension bracket
   + 13.14. Fixing element of a back nave
   + 13.15. Steering wheel
   + 13.16. Tips of steering draft
   13.17. Replacement of protective covers of steering transfer
   + 13.18. Steering transfer
   + 13.19. Pump of the amplifier of a steering
   13.20. Air removal from steering system with the amplifier
   - 13.21. Wheels and tires
      13.21.2. Replacement of wheels
      13.21.3. Running in of tires
      13.21.4. Storage of tires
      13.21.5. Balancing of wheels
      13.21.6. Antisliding chains
      13.21.7. Pressure check in tires
      13.21.8. Check of a profile of tires
   13.22. Corners of installation of wheels
+ 14. Body
+ 15. Electric equipment
вакансии - Москва



13.21.8. Check of a profile of tires

GENERAL INFORMATION

Preventions

Tires can be maintained to achievement of depth of a profile of 1,6 mm, that is flutes of a profile should have depth on all surface of the tire not less than 1,6 mm. However with a view of safety it is recommended to make change of tires at depth of a profile of 3 mm.

Tires M+S on snow have sufficient coupling with the road at depth of a profile not less than 4 mm.

It is necessary to survey the tire on existence of cuts and to establish their depth. If cuts reach a cord, the steel cord will be корродировать from getting moisture.


Intensive wear of tires is promoted by a sports manner of driving, intensive accelerations and sharp braking.