Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
+ 1. Maintenance
- 2. Engine
   2.2. Operations on engine repair on the car
   2.3. Top dead point of the first cylinder
   + 2.4. Cover of a head of the block of cylinders
   + 2.5. Inlet collector
   + 2.6. Final collector
   + 2.7. Gear belt and pulleys
   2.8. Replacement of a forward sealing ring of a cranked shaft
   2.9. Replacement of a sealing ring of a camshaft
   + 2.10. Camshaft and pushers
   + 2.11. Head of the block of cylinders
   + 2.12. Oil pallet
   + 2.13. Oil pump
   + 2.14. Drive flywheel / plate
   2.15. Replacement of a back sealing ring of a cranked shaft
   - 2.16. Suspension bracket of the power unit
      2.16.2. Replacement
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment



2.16.2. Replacement

GENERAL INFORMATION

Preventions

At existence in a code radio receiver against theft, before an accumulator detachment, check that you have connection codes.

On models since 1993 the system of an airbag of safety is disconnected, if the accumulator is disconnected for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for restoration of operability of system.


PERFORMANCE ORDER

1. Remove a weight wire from the accumulator. Using the load-lifting mechanism, support the engine.

2. For removal of the right suspension bracket of the power unit unscrew a nut and take a coupling bolt from a suspension bracket.

3. Unscrew nuts of fastening of a suspension bracket of the power unit to an arm and remove a suspension bracket.
4. For removal of a back suspension bracket of the power unit take rubber jams from a body for access to three nuts of fastening of a suspension bracket.
5. For removal of a forward suspension bracket of the power unit unscrew a nut, fixing an elastic element to a basic arm of the engine. Then unscrew three nuts of fastening of a suspension bracket to a body of the car and remove a suspension bracket.
6. Installation is made in sequence, return to removal.