Toyota Camry

1992-1997 of release

Repair and car operation

Kamri's Toyota
+ General data
+ 1. Maintenance
- 2. Engine
   2.2. Operations on engine repair on the car
   2.3. Top dead point of the first cylinder
   + 2.4. Cover of a head of the block of cylinders
   + 2.5. Inlet collector
   + 2.6. Final collector
   - 2.7. Gear belt and pulleys
      2.7.2. Survey
      2.7.3. Installation
   2.8. Replacement of a forward sealing ring of a cranked shaft
   2.9. Replacement of a sealing ring of a camshaft
   + 2.10. Camshaft and pushers
   + 2.11. Head of the block of cylinders
   + 2.12. Oil pallet
   + 2.13. Oil pump
   + 2.14. Drive flywheel / plate
   2.15. Replacement of a back sealing ring of a cranked shaft
   + 2.16. Suspension bracket of the power unit
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment

2.7.2. Survey

GENERAL INFORMATION

Preventions

Do not overwind and do not bend a gear belt. Exclude hit on a gear belt of the oil, cooling liquid or fuel.

If there was a rupture of a gear belt on the working engine, it is possible that there was an impact of pistons about the valve therefore the valve can be погнуты. Check gaps of valves. On pognuty valves klapanny gaps will be much more demanded.

PERFORMANCE ORDER


1. Remove single pulleys and check a condition them подшипни ков. Check a condition of a spring and check a spring dyne in a free condition.	2. If there was a vykrashivaniye of teeths of a gear belt, the ignition distributor, the water pump, the oil pump or a camshaft are probably jammed.
	3. If there is a considerable wear or stratification on an external surface of a gear belt, check a condition of a racetrack of single pulleys.
	4. If there is a wear or damage only on one party of a belt, check directing a gear belt and alignment of pulleys of a gear belt.
5. In the presence of any defects on a gear belt it is necessary to replace it. Periodic replacement of a gear belt should be made through 100 000 km of run of the car.